Detcon 880S-N1R Manual de Instruções descarregar pdf (Página 21)

1600A-N1R

1600A-N1R Instruction Manual Rev. 0.1 Page 17 of 38

Figure 23 Accessing Serial Setup

Figure 24 Serial Setup screen

Addressing Serial Sensors

When connecting to a Detcon Model 600 or Model 700 Series sensor, the addressing procedure is different.

First, note how the gas sensors are addressed. Each sensor must be set to a different address. The addresses

start from 01 and count up to 16 (hex 10). An example is shown below to explain the procedure. To address

the gas sensors, set the following:

CH # Sensor Address CH # Sensor Address

01 01 Hex 09 09 Hex

02 02 Hex 10 0A Hex

03 03 Hex 11 0B Hex

04 04 Hex 12 0C Hex

05 05Hex 13 0D Hex

06 06 Hex 14 0E Hex

07 07 Hex 15 0F Hex

08 08 Hex 16 10 Hex

NOTE: the CH# is the gas channel number displayed on the Main Display. The sensor address is the

serial ID address (in Hexadecimal) set at the 600 or 700 Series sensor.

NOTE: The 1600A Device # is in decimal format, and the serial address switch setting for the 600 or 700

Series Sensor is in hexadecimal format. This means that device number 10 decimal on the 1600A

corresponds to the 600 or 700 Series Sensor at address 0A hexadecimal.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Sem comentários

Detcon 880S-N1R Manual de Instruções Página 21