Detcon 880S-N1R Manual de Instruções descarregar pdf (Página 23)

1600A-N1R

1600A-N1R Instruction Manual Rev. 0.1 Page 19 of 38

Figure 27 Model DI-4 Module

4.1.6 4-20mA Output Setup

This menu entry is used to address Detcon AO-4 modules 4-20mA output.

NOTE: If there are no AO-4 modules being used, do not enter any device and address information on this

screen. Misinformation entered here will cause the controller to generate a ‘No Communication Fault’.

Figure 28 Set-up 4-20mA Outputs

For example, assume setting up two AO-4 modules. Make sure to set each AO-4 module to a unique ID#

using the front panel switches. If Device #s 1 through 4 are already being used for DA-4 and RL-4 modules,

then set these two AO-4 modules to 5 and 6. The entered values should then look like this:

CH# AO4 Address

01 thru 04 81 Hex

05 thru 08 85 Hex

09 thru 12 89 Hex

13 thru 16 8D Hex

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Sem comentários

Detcon 880S-N1R Manual de Instruções Página 23