Detcon PI-600 Manual do Utilizador descarregar pdf (Página 28)

Grab the lamp by the cylindrical glass body and clean the window by rubbing it against the polishing pad. Use a circu-

lar motion and try to keep the window surface flat relative to the pad. Five seconds of rubbing should be enough in

most cases. Another indication of cleaning completeness is that about 1/16th of the pads surface is used in the process.

Reassembly

1) Install the lamp into the sensor, making sure that the lamps metalized pads are aligned with the corresponding exci-

tation springs inside the lamp cavity.

2) With the end of the clean tweezers, or a clean blade of a screwdriver, press down firmly, being careful not to scratch

the surface of the lamp.

3) Using fine tipped tweezers, install the cell assembly. Align the pins with the corresponding sockets on the sensor

PI-600 Toxic Gas Sensors PG.28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 36 37

Sem comentários

Detcon PI-600 Manual do Utilizador Página 28